Printing a tall resin model can leave you with a second size constraint: can the complete part fit in your curing station? The ANTINSKY Antmega Cure is designed for post-curing larger resin prints and batches of smaller parts. ANTINSKY lists a maximum curing space of 350 mm in diameter by 400 mm in height, 385 nm and 405 nm LEDs, and an adjustable timer.

Measure the part in its curing position
Measure your largest model with any stand or fixture you intend to use. A long rectangular model can exceed the available diameter at its corners even when each side is shorter than 350 mm. For a small batch, leave space around each piece so adjacent parts do not shield the surfaces that need exposure.
Choose settings for the resin
Check the resin supplier’s recommended post-curing wavelength, time and any required temperature before selecting a cycle. The dual-wavelength LEDs give you a wider range of resin instructions to compare with the machine specification. For intricate or hollow geometry, check whether the supplier calls for repositioning, separate treatment of internal surfaces or a specific fixture.
Record the first batch
Follow the resin manufacturer’s cleaning and drying procedure before curing. Note the resin, part arrangement and cycle settings, then inspect the result before using the same layout for a full batch. If the material or part geometry changes, recheck the cure requirements.