BlueCast Cr3a LCD/DLP

$79.00

【One of the Easiest Castable Resins】 Easy to print with excellent casting results — no complex, tricky treatments involved.
【No Hot Water, No Boiling】 Unlike other monomer-based resins, Cr3a only needs washing after printing and curing — no hot water wash, no boiling and no overnight curing.
【0.00% Ash Residue】 Leaves no ash residue after burnout (TGA at 750 °C for 4 hours), for clean, complete casting.
【Low Viscosity & Low Odour】 Formulated for precise prints with minimal shrinkage and very little smell.
【Broad Exposure Compatibility】 Cures at 385/405 nm with layer heights of 30/40/50/100 µm; wash in alcohol and cure with BlueCast curing liquid under UV for 30-40 minutes.
【Recommended Applications & Benefits】 Ideal for jewellery, coins and medals, dental work and filigree that needs a clean burnout. It removes the boiling and overnight curing steps of other castable resins, so you reach the casting stage faster — with consistent results for entry-level and volume users alike.

Size guide

$79.00

BlueCast Cr3a for LCD Printers

Size: 500 g

– Consistent casting quality as BlueCast standard

– Ash residual 0.00% _ proprietary TGA at 750°C / 4 hrs without contact to air, in a closed vessel

– Low cost – Negligible shrinkage

– No primer needed

– Monomer based resin (tested as not toxic / not carcinogenic)

– High resolution

– Good strength

– Fast printing speed

– Very low odor

– Very low viscosity, no need to heat

– Chromacure® will tell you when post cure is done and the pattern is ready to cast

Click below to see the Instructions:

BlueCast Cr3a Curing Liquid Instructions

Customer Reviews